This FAQ describes the simple first setup of Auerswald VoIP systemphones by using zero-touch configuration thus setting the phone's provider and account configuration by the PBX (basic provisioning).
Supported by the following PBXs (from version 6.6D):
- COMpact 4000
- COMpact 5000/5000R
- COMmander 6000/6000R(X)
Supported by the following IP systemphones (from version 2.6B):
- COMfortel 1400IP
- COMfortel 2600IP
- COMfortel 3600IP
Technical requirements:
- Active DHCP server on the network
- Phones are integrated into the network (e.g. by PoE Switch)
- Phones are in factory default settings
- Phones network-settings have been assigned by DHCP
Screenshot of the phone's Zero-Touch-configuration (only displayed in factory default):
3. Assign the correct MAC-address to the subscriber:
4. When the provisioning-file and MAC-address are assigned to the subscriber the provisioning process of the phone starts. To see whether the process was successful check the status of the internal subscribers in "Monitoring":
Note:
The Phone language can be set in the pbx: